1. Create a good heat dissipation environment, and place the power adapter in a place that is not exposed to sunlight and ventilation. Remember not to use it too long at high temperatures. If you
1、 After the new energy vehicle battery is fully charged, connect the battery, Ammeter and resistance wire according to the figure below. 1) Use a multimeter to measure the voltage of each battery
It is strictly prohibited to lose power during storage It is strictly prohibited to store the battery in a state of low power. Low battery state refers to the failure to charge the battery in a ti
Analysis suggests that in the next few years, Japan will lead the United States, Europe, and other countries in intellectual property competition in the field of new energy vehicles. However, due
In the formula, C is the actual capacity, U is the discharge voltage, I is the discharge current, R is the discharge resistance, and T is the time from discharge to termination voltage. Nameplate
Long charging may cause overcharging. Lithium batteries or chargers will automatically stop charging after the battery is fully charged, and there is no so-called "trickle" charging that
For the "activation" issue of newly purchased lithium-ion batteries, there are numerous claims that the charging time must exceed 12 hours and be repeated three times in order to activat
Two separate electronic protections must be provided for overcharging, discharging, and overcurrent. Remove the protective board and charge it. If the battery explodes, it indicates poor design. R
The types of battery cell explosions can be summarized as external short circuits, internal short circuits, and overcharging. The exterior here refers to the exterior of the battery cell, includin
1、 The use of electric vehicles At present, most of the electric vehicles in China are powered by Lead–acid battery. The weight of the battery itself is over ten kilograms. If a lithium-ion batte